Share:

[Closed] Necks and fretboards  

   RSS

0

Glueing on the heel blocks, cutting fret slots and CNC machining the trim jigs for the neck mortise and tenon joint. I have now installed the truss rods and cover caps and then pulled the rods out after about 30 minutes. Took a bit of a tug but got them all out without any damage. They seem to push back in without too much force so once the tenons has been machined and the neck fit established they can go back in for the final time.

8D07B1D4 C173 4478 B359 FA1EB9F5978F
71223CB4 9EB3 45CF A133 84B643BE9E09
68F707DA 6465 45D0 A0D1 0294CBF6242D
8D33E750 643A 452F AED1 AE79098EE670
D4BFFB90 095C 466B B539 A1389B31CF37

1 Answer
0

Hey Darren - great work!

this should really be in the 'showcase' section rather than the Q's:

https://guitarmaking.co.uk/community/showcase-acoustic/

Measure twice, cut once...