0
25/03/2023 4:31 pm
Topic starter
Customer
Rep Points: 6
New Member Hey everyone. About to start my first build. Question for you all on the neck angle jig. Mark says to use 2x4 blocks on the jig. Would I use 2x4 that actually measures 1.5x3.5 or cut down a 2x6 to get 4in exact? Thanks!
Bpower 25/03/2023 10:57 pm
@tdunn0412 I would just use the builders lumber 2x4 (1.5x3.5") or any scraps that will hold the router above your work. If it turns out to be a little too short because of the .5" then just glue another small strip of wood on top... but I don't think you would need to.
