@tej Also, like I said earlier, put a small amount of bees wax on the thread of each screw. Doing this lubricates and eases the action of putting the screw in, it helps take strain off the screw. If the…   Read more»

Posted by: @tej Didn’t use power tools, just not used to hard woods and used an incompetently small pilot, clearly not the strongest of screws either mind 🙂 @tej My rule of thumb: whatever screws you want to use for…   Read more»

Some more fancy back masking and it’s now ready for primer, again! 

Simple little amp – I really only made it to practice my soldering skills.  Mini-toggle is a grit-switch (more, or less), following by tone, gain and volume.  Drives pretty much any speaker.  Sounds pretty raw through a 10″ Jensen with…   Read more»

I sanded it back today and some spots needed some more filler, just a very thin skim. When this is dry I’ll sand it flat and then mask up for more primer. 

[Read more]

is it the case you need to build it up slower leaving more drying time? @tej It would probably sink anyway, however I applied it. It’s good that this happens because it shows that things are not quite right and…   Read more»