Shiny!! @bpower. 😎✨ 🎸🎶🙂🙏

@bpower Looks great

Well. After spraying all the top coats and letting it sit for a few weeks to gas off.... I'm ready to start wet sanding and attempting a glossy finish. Or at least as good as I can do with the tools t...

@koendb Elvis has left the building

And the Lefty Electric Ukulele has found a new home. My first self-built sale !Weird to let go to be honest. Anyway, I am currently building a new one, this time a right handed 🙂

This is My Favourite Song For This Moment.... 🙏🙂🎶🎸

This is My Favourite Song For This Moment..... 🙂🎶🎸🙏

Wow..thank you for the explain...

Thank you. Now I understand more.

The neck is all set and tomorrow it's time to start the body. Attachment : 20220729_204859.jpg

@wayne_f Nice work! you got this.

@rocknroller912 Yes, but the taper template was only off by a little under a mm. As long as the fretboard is properly centered, the slot should be fine and the edge can be blended out. Attachment ...

This is My Favourite Song For This Moment..... 🎸🎶🙏🙂

@wayne_f Did you just leave the slot as it was

Truss rod is installed and fretboard is glued down. This time I rounded the end of the fillet at the heel end so there's no open gap. Attachment : 20220723_183345.jpg Attachment : 20220723_...

Posted by: @robin @wayne_f These problems we give ourselves never seem so bad after a good night's sleep, you'll fix it and it'll be fine. @robin That's very true. Sometimes it doesn't even take ...

@rocknroller912 Thanks a lot! I will give that a try to remove the pickguard 👍

@bpower thanks for that info! it will be useful 👍

@koendb Bakelite does get very brittle and I’m not sure about the best way to remove it. Try some warm water around the edges. At the time it was made people only used water based glue I think and it...

@koendb I've seen that you can get the "bar type" fret wire from . There are probably other places but that's the one that I seen and read about. I read about it from the fret book I got from stewmac...