@boo coming along nicely. Any advice when it comes to the neck angle By the way? Seems like a critical point with little science involved to get it right?

Attachment : st,small,507x507-pad,600x600,f8f8f8 (2).jpg 😂🎶🎸🙏

This is My Favourite Song For This Moment.....wakey wakey. 🙏🎸🙂🎶

You mean, some people have *real* friends, not just virtual ones?? @tv101 Yes, back in the olden days people could meet other people, shake hands, hug, chat face to face sat next to each other. Somet...

You mean, some people have *real* friends, not just virtual ones?? It appears to be occurring.

@cheesewhisk ok, see what you mean, I’ll pay extra attention when I get to the same bit.

I didn’t manage to get the pin in the hole on the 10th fret, I think I just dug into the wood and thought it was in.

I had no idea it was such a manual process or that there were so many stages. But it did only take 2minutes ...

Attachment : st,small,507x507-pad,600x600,f8f8f8 (1).jpg Attachment : st,small,507x507-pad,600x600,f8f8f8.jpg 😂🎸🙏🎶

Hey @marcel. You're all grown up again. 😁 🙏🎸🎶🙂

This is My Favourite Song For This Moment......if this doesn't get you dancin', nothing will. 🙂🎶🎸🙏

This is My Favourite Song For This Moment...... just chillin'. 🎶🙂🎸🙏

Yep, first time used in anger Russ. It’s rather good, I’m really impressed Very neat @boo. Looks great. 🙂🎸🎶🙏

For anyone who’s interested there is a lesson in the Acoustic course on laminating headstocks. Just watched that 2-3 weeks ago @tej. All good stuff. 👍😁 🙏🎶🎸&#...

Mark's knowledge is invaluable to us. Couldn’t agree more @russ. For anyone who’s interested there is a lesson in the Acoustic course on laminating headstocks.

@mattbeels pretty much but I’ll sand the veneer to roughly match the rough headstock profile. Suggestion from Mark is to drill an 8mm hole and ream it out to 10mm to remove chance of breakout. Don’t h...

@russ so I mentioned to Mark about this and I need keep the headstock “core” over 13mm That's good to know @tej. Mark's knowledge is invaluable to us. 🙂🎸🎶🙏

So what’s your plan for this repair @tej? Glue on one veneer then drill out the four tuner holes and then repeat?

@russ so I mentioned to Mark about this and I need keep the headstock “core” over 13mm which makes sense, I think I might just surface route .5 to .8 mm off each side and then route the veneer down so...

Hi @tej. If you haven't already glued it down, you could rout another 1mm off the headstock. If you have then be very careful not to rip it off with the router. Maybe you could just sand it down. &#x...