That'll be great if you could post that to me. @robin OK, consider it done.

Thanks for the advice @Rocknroller912, I've plenty maple offcuts and it's not really in a conspicuous place so the bigger bit that I cut out will be mostly hidden inside the neck pocket.

Thanks @boo , that should do the job. That'll be great if you could post that to me.

I have an embarrassing amount of "stuff" on my workshop shelves that I've either bought with good intentions of using (but haven't), bought but decided to use something else, bought because I was buyi...

I have an embarrassing amount of "stuff" on my workshop shelves that I've either bought with good intentions of using (but haven't), bought but decided to use something else, bought because I was buyi...

Do you mind? I resemble that remark! @jonhodgson 🤣👍

@boo Do you mind? I resemble that remark!

@jonhodgson Do you normally have someone that looks after you? 😆

I think I must have started an order then stopped either because something else came up or the next item I wanted was out of stock. Then when I went back a week or more later I forgot to check that th...

Listen to MSG, got it...

MDF not msg That would have confused me!

MDF not msg

Cheers @tv101 its 18mm msg with a couple of 1x2 pine rails. Ive just got a very similar bit but it’s good to know decent places to buy from. 2mm is too much, that’s great, that’s definitely where I’ve...

That's a very handy jig. I've got something similar, and it's got me out of jail a few times. Pointers; Looks like your workpiece is secured in place - make sure you wedge it on the sides too, so it ...

Attachment : IMG_0347.MOV Attachment : 5BF8B477-A202-442F-A542-873D8032534D.jpeg getting back on the horse as they say, because my blank needs a bit of work (I bought before I found Mark) I...

What are you thinking of *making* for your first guitar? @tv101 Now that's a question, I'm truthfully not sure, ideally I'd like to make an instrument that I never want to part with but also would li...

@lemonshoes Its not the way I would do it, but you should get some more opinions on here before starting. There are some very experienced builders on here who use power tools a lot and I mostly use ha...

there is bound to be a video on the site somewhere @rocknroller912 Good one mate 😉

Sorry if I was a bit unclear about that. The fretboard would be on the neck when I route the channel. The neck would still be flat on the sides, i.e., not carved yet. So the side of the neck would be...

@lemonshoes To route a binding channel there has to be a reference point for the router guide bearing ot a straight edge to work from, so I don’t know how you would get this unless you finished the ne...