@powerful. Those sides look great. When doing the first one you really have no idea of how far you need to bend to get it close. Watching Mark do it on the course, and when he gets it so close the fir...

If those pics you posted were of the "near disastrous" first time that you've tried bending sides, and then the morning-after re-bend, then I think you put that down as a big success. OK, there's some...

Posted by: @robin Scewfix have 25m coils for about £43. Thanks @robin. I'll take a look. 👍 🙂🎸🎶🙏

@russ I'm hoping to eventually get armoured cable fitted but the shed in about 25 metres from the fusebox. Scewfix have 25m coils for about £43.

Posted by: @boo My extension cable is on a large reel and has a trip switch built into it That's the one I have @boo. 🙏🎶🎸🙂

@russ @tv101 @boo Have you ever run your cable out to your shed on a very wet day and have you found that it's safe enough? I've moved on little from my basic extension cable now. I've fitted a wa...

My extension cable is on a large reel and has a trip switch built into it. I would advise everyone to use one of these, especially when using power outside or when the cable is outside. Safety first.

Posted by: @russ Hi @robin, Have you ever run your cable out to your shed on a very wet day and have you found that it's safe enough? Or ... have you ever found that it's NOT safe enough??

Hi @robin, Have you ever run your cable out to your shed on a very wet day and have you found that it's safe enough? 🎸🎶🙏🙂

Posted by: @rocknroller912 You should change your web handle to slow hand, or is that one taken already. Not a bad idea @rocknroller912. 👍😁 🙂🎶🙏🎸

@russ You should change your web handle to slow hand, or is that one taken already.

Posted by: @russ I'm going to try and keep it from clogging up but the desire to buy the next tool is always there Oh yes! When I put up my first shed, my wife kept asking “are you sure that’s going...

@boo That makes sense on the cold conditions! And a perfect way to justify the space for the "DIY jobs" 🙂

@boo When you move find a house with a workshop space.

@koendb firstly I had the iron too hot and ended up with scorch marks although these were mainly superficial and sanded out ok but my perception of where the bends should be were quite a way out and t...

Just been shopping to Lidl and came home with a bag of chips, a box of washers and a Japanese pull saw (double sided). I don’t know how good or bad this saw will be but for £6.99 it’s definitely worth...

@wayne_f For reference for drilling the routing holes through the body I used a 10mm argur bit with a drill that has a max unloaded speed of 1650RPM and 65NM of tourqe. Apprectiate you dind't have an ...

Hi. Took a massive leap of faith yesterday and bent the side’s with near disastrous results. However after sleeping on it and revisiting the job today I’ve managed to tease them close enough for the n...

@boo Great Ideas! I am certainly excited for the setup to come together, and I know someone who has stacks of pallets, so will be giving them a friendly visit 🙂 It would be great to do an indoor setu...

@seanf I later added a small bench vice that just clamps on; it can easily be taken off for times when it’s in the way. It was cheap and good quality from a good quality vendor, I use them a lot. ...