Coming along very nicely @koendb. 🙏🎶🙂🎸

@keondb Ok I think I picked you up wrong. Do you check the nut to see if it’s flat, a lot of new ones are not. I use a thin chisel as a scraper to get the slot flat and check for rocking with a small ...

@koendb I use the same set up as for cutting the fret slots but with a tapered fret board it’s more difficult to get it square. Clamps as well as tape can be used but the tightening will move everythi...

@koendb Accurate measurements are a learning curve. Mark was demonstrating recently how to fit position marker dots and showed how to double check before drilling with two different ways. This would b...

@koendb Looks like you have the same type of metal fret cutting jig as me. The saw needs to be quite tight in the rollers or it can go off 90 deg. I’m assuming you have the fretboard stuck with double...

Take care guys, sending our love and support.

Hi @koendb, I'm probably still a few steps away from being able to offer them for sale and I need to get the cost of the parts down, specifically the motor system and the shaft, if they are going to s...

That's a bit harsh! He's trying his best! 🤣 🤣 I am trying. 😉

After his pre-unboxing video windup I say it's the least he deserves. 🤣😆🤣😆🤣😆🤣🤣✨✨✨✨✨✨✨&...

@boo can I hold you responsible for anything goes wrong?? would be handy!!!! @steveadams After his pre-unboxing video windup I say it's the least he deserves.

some failure..BOO!!! That's a bit harsh! He's trying his best! 🤣 🤣

@boo can I hold you responsible for anything goes wrong?? would be handy!!!! @robin if you slow the footage down to real time I am going very slowly...ha ha.... cheers Steve

@steveadams I've just watched part V. I'm well impressed with the way that you casually drilled the tuner holes with a handheld drill. When I tried that, I had to plug most of them and then try agai...

but also some failure..BOO!!! @steveadams What have I done? 😆

thanks @tv101 and everyone else who commented... No pressure then @tv101...in fact the next part has some success...YAY!!! but also some failure..BOO!!! standby for more adventures... cheers Steve

We didn’t get a lot of British tv as kids but we sure did watch a lot of Benny Hill Glad it's not just me then @mattbeels. Knowing how @steveadams responds to viewer feedback and strives to produce c...

BTW, if anyone does want advice on banjo building (especially jazz banjos) I believe that TV10101 has a ‘special’ interest in these fascinating instruments! Being serious - just for a minute - ther...

That music always reminds me ....of a little old bald guy getting his head slapped a lot!

Hey Steve, the slight pause after you had drilled four holes in the headstock momentarily made me think you were building a banjo!! Thankfully you quickly redeemed yourself with the last two and so yo...

Am I the only one expecting to see persons in various states of dress, and undress, running around the workshop in the background? No @tv101, you’re not. We didn’t get a lot of British tv as kids but...