Hi Guys, I'm trying to CAD up the design for a Telecasterish guitar (it has certain differences, 24 frets. marginally smaller body, etc) The problem is where to locate the bridge plate (Gotoh GT201, 6...

@jonhodgson Hi Jon, On the plans that I have the back screws are 660mm from the fretboard side of the nut. The front screws seems to be 591mm. Sorry, I had to use a tape measure to measure it but it ...

@jonhodgson ...... forgot to mention that it's a 25.5 inch (648mm) scale length. 🎸🙏🙂🎶

Attachment : 20220811_131213.jpg Attachment : 20220811_131140.jpg Attachment : 20220811_131132.jpg

Time for some money shots. Guitar is done. A couple little things left to do to it but I got some pictures of it. Attachment : 20220811_132341.jpg Attachment : 20220811_132534.jpg Att...

Attachment : A30379B2-CFE6-4FC1-A471-114945E4549A.jpeg

@robin Just too many fingers

Found this on Facebook and thought it was too good not to share Attachment : 7A23B045-4B22-4C7F-AA24-8E49A9577053.jpeg

@bpower its looking fantastic.

Shiny!! @bpower. 😎✨ 🎸🎶🙂🙏

@bpower Looks great

Well. After spraying all the top coats and letting it sit for a few weeks to gas off.... I'm ready to start wet sanding and attempting a glossy finish. Or at least as good as I can do with the tools t...

@koendb Elvis has left the building

Wow..thank you for the explain...

Thank you. Now I understand more.

Posted by: @nossair so does the volute size matter or you need just some extra mms to make the neck stronger? @nossair It depends on what kind of guitar. If it’s a standard guitar I would say it’s ...

Hi @nossair. I'm no expert on the subject but I imagine that the thicker the neck the smaller the valute. If you're neck is made using a scarf joint from a 1" blank then you may need a bigger valute t...

guys i'd love to ask you about the relevance of the size of a volute. some make huge volutes and i find that quiet ugly i'd rather have a small elegant one. so does the volute size matter or you need ...

The neck is all set and tomorrow it's time to start the body. Attachment : 20220729_204859.jpg

@rocknroller912 Yes, but the taper template was only off by a little under a mm. As long as the fretboard is properly centered, the slot should be fine and the edge can be blended out. Attachment ...