Attachment : 20250611_173927[1].jpg plum mahogany stain burst

Attachment : images.jpeg 🙏🎵🎸🙂

Hello, you are doing a great job, I think you covered all the steps. Share the picture of your guitar after completing it. I'm excited to see your attempt!

@russ So I finally discovered the secret to inlays on a maple board. The secret is...... buy a CNC! Attachment : IMG_8244.jpeg

@somethingnicer I've seen a couple of guys using this...... not just on the neck but on the whole guitar. Attachment : big--675c3fbd.webp 🙏🎸🙂🎵

working on my first maple neck and fretboard. I decided to do a separate fretboard for a couple reasons. I’m really happy with how it’s coming along so far. My inlay blocks are poured epoxy. So since ...

Attachment : 20250519_070528.jpg Attachment : 20250519_070317.jpg Attachment : 20250519_070513.jpg Attachment : 20250519_070347.jpg Attachment : 20250519_070401.jpg Hi ...

@scotty Glenisla direction, about 20 miles from Dungdee heading into the hills

@nsj Wonderful build that Neil. I’ve always loved that shape, it’s so rock! 🤘😜🤘

Attachment : IMG_8438.jpeg Attachment : IMG_8419.jpeg Going Green

Attachment : IMG_8082.jpeg Attachment : IMG_8101.jpeg

@nsj thx for info, i am still in doubt if i will carve bye hand or use templates.

@somethingnicer You did all the right things. It's just incredibly difficult Inlaying onto a maple fretboard. Just keep practicing until you become the master. I have seen people use the black super ...

I'm working on a difficult fretboard inlay and am struggling to find the best method, maybe someone here has some advice..... I'm working on a maple fretboard (separate from neck), and it needs block ...

I'm working on a difficult fretboard inlay and am struggling to find the best method, maybe someone here has some advice..... I'm working on a maple fretboard (separate from neck), and it needs block ...

@nsj I've just been watching you finishing it this morning. Nice work again, Neil. 🎸🙏🎵🙂

Friend asked me to build him an explorer. Turned out decent. Pickguard is ash epoxied to 1mm aluminium then sprayed black, headstock plate is also ash sprayed black. He has a cnc which he was able to ...

Hey up Scott, I'm about 60 miles or so further north of Edinburger. Welcome to your new life of being poor but surrounded with guitars lol

Do you have access to a CNC to use it? If so there will be an associated CAD program that the owner uses. I would suggest you start by finding that out then looking into how to program with it. I thin...

@nsj That is perfect, exactly the info I was looking for. I was just going to try it anyway using a rough and ready quick build and see how things went. I’ll go for it now then. Cheers Neil 👍