Looks great @powerful, nice work! I’ve never bent sides before and I can imagine how tricky and stressful the first time must be! I guess some scrap to pratice (😉) on would be a good idea… I l...

@powerful. Hhmmmm.... I'm not sure about rebending the side with the kerf lining on it. If it was me I would probably remove the kerf lining and bend the side again until I am happy and then glue more...

Yep, they fixed it last week. I'm only concerned about the eggheads fixing covid now, I couldn't care less about England's Brexit. Roll on Scottish Indy2. I'll be there soon. 🏴󠁧฀...

Nice neat work @powerful. 👍😁 🙂🎸🎶🙏

Yeah, nice work @powerful

@powerful Very nice work sir, keep going. 👍

@powerful. Looks good. When you say you are offering up the sides that you need to tweek a bit.... do you mean you still need to bend them a little or are you lining them up to mark the braces to fit ...

@powerful. Those sides look great. When doing the first one you really have no idea of how far you need to bend to get it close. Watching Mark do it on the course, and when he gets it so close the fir...

If those pics you posted were of the "near disastrous" first time that you've tried bending sides, and then the morning-after re-bend, then I think you put that down as a big success. OK, there's some...

@powerful awesome! that is looking pretty good to me. Cant wait to see the next stages 🙂

Coming along nicely @powerful. 👍😁 🙂🙏🎶🎸

@powerful looks great. We'll done. Acoustic rock. 🙂

That's great work there @powerful I'm looking forward to seeing this progressing.

Looks like you’ve bought some great products there BPower! I took delivery of some soundboards from NW Canada only last week and I really hope you’re not in one of the stupidly hot regions, doesn’t lo...

Posted by: @ Not sure if that steam generator would be hot enough, I have one but unless there is something wrong with it ,just doesn't produce enough heat to enable a easier bend .

GREAT! Let us know if you have any trouble...

@powerful it is a snug fit but not tight. I dont think it needs to be a tight fit though. Just set it up so the heat gun doesn't fall out of the end when you are bending it. Not that it is a big fire ...

Posted by: @ And people used to just point a torch in the end of the tube for a heat source and that would not be a tight fit. It is just directing the heat down the pipe. Also.... do not use galvan...

It is really not a good idea as you will fill your workshop with steam, thus causing all your precious timber to warp, and your benches, and your walls, and your mind. Seriously thoo...There is normal...

@powerful . I just used a pipe and a heat gun. I got a 1 1/2" pipe that would fit over my heat guns tip. Put a bracket on in so I could clamp it in my vice. It is pretty low tech but it worked for the...