Hello, I decided to challenge myself with a neck through 12 string semi hollow telecaster style guitar, the wood has been acclimatising in the garage for a few weeks now, but I decided to make a full ...

@rey_rchotmail-com Welcome! Nice kitchen equipment you have there! 😉

Hi @rey_rchotmail-com Welcome on this forum! Nice bandsaw!

@russ lol

Welcome aboard you're new addiction lol. 6tpi 3/8ths here too

@Koendb that looks like an adequate compressor for small jobs like finishing a guitar. Go for low volume airgun - that way you wil have more control over the thickness of the finish layer. High volum...

@peter-c-f In which case would I need to lubricate? nail guns and such? Anyway, yes only spray paint and maybe just air to clean out something, but I believe most of the ( cheaper ) compressors alread...

I would suggest that for your air compressor you make sure it has an accumulation tank included (that way the volume of air available is always more than you need). Also. make sure you bleed/drain th...

I suppose this one is up to @Boo 's sleeve: I am considering getting my feet wet into spray painting, after having bought a small cheap airbrush setup for touch up work in guitar repair.To do the occa...

Excellent repair job @koendb. Toolbox? 🤔.... there's an idea. 🙂🎶🙏🎸

The Renaissance guitar build is on hold until september, but I started making a mold for a dreadnought guitar, I am planning to build a 12 string and a bass guitar next. Meanwhile I am working on som...

Cheers @koendb. How's your build coming on? 🙂🎶🙏🎸

@russ wow nice work 😍 It is starting to itch...

I do like that fretboard @nsj. 🤌 🎸🙏🎶🙂

Frets in, markers and side dots done, next up it's carving the neck and volute. Attachment : 20230806_164550.jpg Attachment : 20230806_164557.jpg

Then I carved out each end of the centre strip to accommodate the heel block and end block. Attachment : PXL_20230209_135932639.jpg Attachment : PXL_20230209_133648378.jpg 🙏...

Time to carve the back braces into shape. Attachment : PXL_20230209_113055517.jpg Attachment : PXL_20230209_101904324.jpg 🎶🙂🎸🙏

Then glue in the four back braces. Attachment : PXL_20230203_115306628.jpg 🙏🎸🙂🎶

The next stage was to mark out each of the areas of the centre strip where each of the four back braces will pass through. Then carve them out Attachment : PXL_20230203_092142104.jpg Attachm...

@rey_rchotmail-com Welcome Rey. Enjoy the ride. Hope you don't get too much sawdust in your dinner. 😂 🙂🎶🎸🙏