A little update - since the last update I've routed the pickups, did a load to the headstock, fitted the tuners, flattened, put a 16" radius in the fretboard, frets and levelled and fitted the fretboa...

Finally got the first coat of finish on the body, and added my mates logo to the back of the headstock. Chris Mckean Music Attachment : 20231218_015537 (1).jpg Attachment : 20231212_151430....

@markbailey Thanks for your input Mark, I've read the book and I think, with me being an engineer, I got caught up in theory and numbers. I'll stick with your brace carving directions, I've also deci...

If you are going to 'tune' any of the braces, plates, chambers make sure to offset your tuner by 1/4 note (A=431) The last thing you want is parts tuned to concert pitch. Until you have a few builds u...

@liebe I went to deep once, measured from the lip for the cover rather than the back of the guitar lol. I used the template to draw the shape on a piece of wood, cut it etc then glued it in and the...

Well, I started giving updates of this build so I'm going to continue....! I've I managed to get all the binding glue out, fretting went well and no issues under cutting the fretwire for the binding. ...

@robin Thanks I haven’t seen this before and only have his mandolin book. For a first build I would stick with Marks course and it will be a good guitar. Tap tuning is fairly advanced.

It certainly was not my intention to send you 'doon a wabbit 'ole'. I am sure that you will make a good sounding guitar whatever route you choose. After all, best results are based on guidance as well...

@rocknroller912 @peter-c @markbailey This is an extract from the book ( 'The Art of Tap Tuning' by Roger H. Siminoff ) these are suggested target notes (not definitive) for the braces with the sound...

@Rocknroller912 Thanks for your 3explanation. You describe what happens, I was attempting to describe why - so I gues we complemented each other in thid conversation 😀

@nsj thanks neil, I entered the scratch build category this year only JUST finished in time, I did a sound demo here

@rathius yeh I've been using those, I do a shallow recess in the top for them to push into so the nob can still sit flush at body height. But I wire all that point to point then just hook up the pi...

@nsj yeah I suppose if you’re only using regular pots but I use push/push these days. Did use push/pull but switched earlier this year. I do all the wiring on the pots before they ever get close to a ...

@rathius for joining wires but you're connecting wires to tabs, back of pots, side of switches etc. I'd use them to fix a car though lol

Y’all talking about soldering and all but have any of you seen these? Clear heat shrink loaded with a small ring of solder in the middle. Stick your wires in each end then use a heat gun. Tubing shrin...

@tyreman what category did you do? I did the community but finished about 3 guitars ago lol Good job on the build, is there a sound demo coming up?

@tyreman. 👌Nice. 🙂🎶🙏🎸

@boo thankyou

@swepri I'm happy with the balance, maybe a bit neck heavy so if anything the body could have been solid and it might have been a little bit better balance wise, the real test will be putting straploc...

@peter-c-f The sound waves on bowed and plucked instruments are different. I watched a science demo when I attended classes at violin school using transducer pick ups and an oscilloscope. For bowed i...