I’d start off looking at something suitable for an airbrush that I could store on a shelf in my flat, and before I knew it I’d be looking at the Turbo Mega Compressor Pro Triple Plus and thinking “well, I…   Read more»

I’m a bit worried about copy routing the pointy bits, any advice on avoiding tear out on those areas. Usual rules – take small depth of cuts with each pass and – if your router has a speed control -…   Read more»

It took almost as long to separate the two templates as it did to route them as the double sided tape didn’t want to let go.   Forgive me if you know this already, but sometimes a “twisting” movement between…   Read more»

Have a classic from me today

Like that @rocknroller912 – thanks.

My only concern is that this is quite a big cutter to be using in what is essentially a hand routing jig Good point.  I should have said that I usually aim to take off *fractions* of a mm in…   Read more»

I’ve had sorts of odd people drop in!!

You mean you had *other* visitors too???