Truss rod fillet planed and scraped, ready for the fretboard. Attachment : 50E14A42-8891-4070-A9E4-0C8B0F6F4565.jpeg Attachment : 1E9B6F29-D3E7-4C1F-AA36-A89B5B07468F.jpeg Attachment...

Good choice on the tuners @boo, I love locking tuners and the low profile posts are a big reason why. 👍

@boo coming along nicely, hoping to be at a similar stage by the end of today too if the stars align and I get time!

Did a little bit more on this neck today. Drilled the tuner holes and rough cut the headstock. Installed the truss rod and glued the fillet in. Test fitted a couple of tuners and had to put the neck b...

No surcharge with these guys, but there is a £12 minimum order @jonhodgson That’s great, thanks for the link, I’ve ordered from them. I made up the order with a few different colours to get it to the...

Do you think there is any reason why this material couldn’t be used to make fret marker dots? @boo I don’t see why not, should look good. With regard to size look at how wide your fret wire is and w...

@boo that's a bit cheeky! No surcharge with these guys, but there is a £12 minimum order

These guys have 6mm, which is about normal for a dot @jonhodgson Ah yeah but look what happens when you put a couple of 6mm rods at 600mm in length into your basket and try and purchase them. Thanks ...

@boo These guys have 6mm, which is about normal for a dot

What size are you after @boo? It looks like they have everything available unless I missed something... @mattbeels Erm, I was thinking 9.5mm is a bit big for fretboard dots or is it acceptable? Not s...

What size are you after @boo? It looks like they have everything available unless I missed something...

I know you’re going to paint it @boo but I was thinking that the mismatch of the grain on the headstock would seep through... but I guess that you know what you’re doing, right? 🤷🏼...

Coming along nicely there @boo. 👍 🙏🎶🎸🙂

Are you gonna use a headplate? @mattbeels What, like a cap, a veneer? Do you think I should? I was thinking of just painting it.

Lookin’ good @boo! Are you gonna use a headplate?

It’s starting to resemble a neck now. Attachment : 85D61C76-E87E-4607-B575-411C5E239524.jpeg Attachment : 909F6F44-F221-4D60-8155-0C34C56D4F3C.jpeg Attachment : B3B42F50-996C-4208-8...

A bit more marking up before getting it back into another jig for headstock thicknessing. Attachment : 3BF458B2-92C5-4DB8-A06B-9CC0EB8CB251.jpeg Attachment : 187F0507-1993-4FF5-B51A-8FB9E9...

Into a jig for more routing of the headstock. Attachment : 4DDA38EE-95DA-446A-98BC-6B87D9AEE65D.jpeg Attachment : 42B3F405-6D06-4FBB-91B1-31843A43D3AA.jpeg Attachment : F23899C6-959...

A bit of routing on this neck today. Attachment : 76B958E8-10DE-4892-BBD9-B921EEF58682.jpeg Attachment : C74C1391-7865-4332-931C-466BF7A48578.jpeg Attachment : A9EB86DD-7E03-4C44-B6...

Bumblebeesman @mattbeels 🤣🤣🤣🤣🤘🎸