Frets in, markers and side dots done, next up it's carving the neck and volute. Attachment : 20230806_164550.jpg Attachment : 20230806_164557.jpg

@russ I actually started this one while waiting on stuff arriving for the last one, got all the scarf joint done, trussrod in, fretboard slotted and glued on etc. I try to procrastinate but my brains ...

Your putting us procrastinators to shame @nsj. 🤣😂 🎸🙏🎶🙂

Building my own version of a strat this time, 3 single coils, 5 way blade etc. So far I've been working on the neck, today I got the fret markers done. Next will either be frets in or carve, haven't d...

Thank you very much

Hello @rey_rchotmail-com, a very warm welcome to you at Guitarmaking community.

@rey_rchotmail-com Welcome! Nice kitchen equipment you have there! 😉

Hi @rey_rchotmail-com Welcome on this forum! Nice bandsaw!

@russ lol

Welcome aboard you're new addiction lol. 6tpi 3/8ths here too

@rey_rchotmail-com Welcome Rey. Enjoy the ride. Hope you don't get too much sawdust in your dinner. 😂 🙂🎶🎸🙏

The bandsaw you have there looks great! That will do nicely... I use a 6 skip 3/8" blade for almost everything.

Just want to say hey and ask a question. What size of band saw blade should I use!?! I have a 14” porter cable saw. Would like to mention I work from the kitchen! lol Attachment : 91CA7E7E-9840-...

@Koendb that looks like an adequate compressor for small jobs like finishing a guitar. Go for low volume airgun - that way you wil have more control over the thickness of the finish layer. High volum...

I would suggest that for your air compressor you make sure it has an accumulation tank included (that way the volume of air available is always more than you need). Also. make sure you bleed/drain th...

I suppose this one is up to @Boo 's sleeve: I am considering getting my feet wet into spray painting, after having bought a small cheap airbrush setup for touch up work in guitar repair.To do the occa...

Nice work @tyreman! That is going to be an awesome build 🙂

the top is almost done, I used some hot hide glue to glue on a couple of extra pieces to extend the width, using a rub joint technique, I think carving the neck is going to be next, looking forward to...

Attachment : bookmatched top-1.jpg bookmatched pine top, just need to hand plane it to thickness.

Attachment : jack socket routing-1.jpg Attachment : jack socket routing-2.jpg Attachment : jack socket routing-3.jpg Attachment : jack socket routing-6.jpg Attachment : ja...