Well done Cheesewhisk, looks great so far.

More progress. This is actually starting to look like neck and everything Attachment : 9803B9CC-1C05-4362-AFB3-BA95CB43C4DB.jpeg

Thanks @rocknroller912 big difference wont you learn anything from mine... ha ha thanks for comment. cheers Steve

@steveadams Thanks for doing another video. Missing the live streams a lot so it’s good to watch someone building.

@steveadams. Thanks again Steve. I love your attention to detail. Cheers, Russ 🎶🙂🎸🙏

Hope you enjoy @steveadams Good job Steve, keep going and keep these videos coming, they are great.

thanks @boo & @tv101 I'm a little ahead now...exciting day today but can't share until I've edited... ha ha cheers Steve

@jonhodgson Nerves about starting or completing a job are quite common among craft people. I’ve even heard of professionally trained makers who can’t progress with work because they are terrified of m...

measure again... and again... and a third time just to be sure... cut again...measure... swear.. measure again.... swear again, this time more elaborately and loudly... put down tools and make a cup o...

I may have measured twice Every time Mark says "measure twice, cut once" I think "bollocks, that's not how it goes for me" My reality is more, measure twice, cut... measure again.. scratch head tryin...

@boo D’oh-ily!

I’m so not into that stuff so I can’t even spell doilies properly, d’oh! Psst... don’t tell boo as he’s already on my ass for my spelling! @mattbeels You big doily 😂

Thanks Robin Yes, good point. I think it's easy to get really caught up with mega tiny details and to remember there is tolerance... I'm trying hard to be accurate and most importantly SLOW..ha ha I'v...

@steveadams A great video Steve, keep them coming. You seemed a little surprised that the slot depth was less than 11.5, it probably is close to 11.5 as the flat probe on vernier wouldn't have gone to...

This is My Favourite Song For This Moment..... been dancin'around my kitchen to this..... 🙏🎸🙂🎶

Attachment : 9B833952-787A-49CA-AD63-58C95918C9C1.jpeg

Looking forward to seeing more of this one @clinton!

How sloppy is the neck fit?

I wondered if also what you could do is get the template on position and then, as it's tapered, move it back say 5mm (That's just a guess at this stage) and then rout. I have tried tape on another tem...

I positioned and repositioned to make sure it was right.....but still the pocket is slightly too wide.......don’t know if I used a wrong reference line somewhere, haven’t been back in the garage since...