There's a Dry transfer paper available (Developed in Japan in 1980s) that just leaves the ink + microlayer of adhesive. I use it for my 'Electric La...

Wrong image!!! Try again Custom finish on BKP Cobra Pup

Current thinking

Like this Pickguard

Newest build English Ash grown in Swampy conditions- see width between annular grain! Body about 3lbs Birdseye Maple Neck and Fingerboard EVO...

On the subject of stolen riffs - the reason I took up Electric Guitar was this egotistic, yet talented guy Ritchie Blackmore. Understandably 50% of...

Paint brush dipped in water on inside of 10mm has worked for me (end grain will remain expanded/swollen), but 9.5mm usually works fine for me.

Sliced and Diced doesn't require symmetrical design

Methinks it will make for the coolest coffee foams. More Sugar with that vicar ?

Better view

I used 6mm plug cutter to make Maple & Mahogany dowels for one of the Necks in pic. Careful to align the grain. I think with metal surround, y...

Sorry for typo Rockpile 99

Thanks Rockpile 92 I'm the same scenario as you - miss my olde workshop! Most of the time it works well, it's the cure time that drives me to ...

I'll share this week's disaster with you - Final rubs of this P Bass with 1,500 - 5,000 grit prior to buffing. Wipe off with damp cloth to remove...

Is it possible to do a decorative carve and fill with epoxy then reshape? You'd have to stop anything bleeding into channel. Could be a very cool...

Nicely done. Truss rod routing is so rewarding when it sits in the groove all snug! Getting a tight fitting square level Nut is my current nemesi...

Idigbo Neck Maple Fretboard SS frets Abalone 4mm dots

Cautionary tale: When building the prototype Electric Lady Signature model in 2009, I thought how cool to extend neck to accommodate supporting 22nd...

Coolio!

Thanks