
Seth
Customer
Active Member 

Rep Points: 81
Joined: Sep 7, 2020
Last seen: Jan 23, 2022
Last seen: Jan 23, 2022
Follow
RE: Neck slot error
Thank you everyone, I appreciate all your help.
5 years ago
RE: Neck slot error
@robin yes please post a picture! Yeah that’s what I’m leaning towards doing, im just wondering if it’s enough support after watching a repair video ...
5 years ago
RE: Neck grain runout
all cut out and ready for final cuts with the router.
5 years ago
RE: Neck grain runout
@robin NICE! Yeah i just did the rough cuts for the shapes this morning before work. I couldn’t make up my mind of what to make, so im making two at t...
5 years ago
RE: Neck grain runout
@darrenking thanks, that’s what i was hoping to hear, I will proceed forward then. the worse case scenario is the neck does break, so this will be a ...
5 years ago
RE: Fret sloting oopsie
Thanks Darren
5 years ago
Forum
RE: Fret sloting oopsie
Yes its off by 1mm. I measured with a little $9 angle-izer.
5 years ago
Forum