Lathe it Down. 😆😆😆 @mattbeels Terrible joke. 🤣🤣🤣🤣👏👏👏👏👍  That’s a bummer about the fretboard but it still looks thick enough on the bass side, you should be alright. Good luck! Yeah it will be fine, it’s just a lot of…   Read more»

It looks like there’s more then enough meat on that fretboard no? @koendb Yeah I think there is enough on there to rectify the problem. I quite like the yellow dots now they are in, it’s a dramatic contrast. 

Don’t you mean you’ve carefully crafted an ergonomic radius offset?

@jonhodgson If only it would work like that, I would leave it. 

Is it like that the whole length?

@tej No, it starts from about the 12th and gets steadily worse going towards the nut. 

It worked well apart from the fact that I got a little over zealous with my radius block and because I was concentrating on sanding the inlays so much, I’ve accidentally sanded one side of the fretboard too much. So…   Read more»

I used CA glue and accelerator to instal them with. I then sanded them flush with the fretboard. 

[Read more]

I couldn’t find any yellow fret inlay dots that my customer had specified so I found some coloured acrylic rods so I could make some. Thanks to people on here for helping me find such places that sell it, much…   Read more»