Wow @likeakite! Ican only echo what others here have already said, awesome work!

@boo is it the case you need to build it up slower leaving more drying time?

Dug through the wood bin at the school today. Got the OK before I started to "pull out anything you find in there that you might want, I've got enough shit to last a lifetime and these kids don't know...

This is My Favourite Song For This Moment....... 🎶🙂🎸🙏

There are loads of products out there that I still haven’t tried There are more that I haven’t I can assure you 🙂 I’m somewhat limited by not being set up to spray but there are still quite a...

What you got planned next? You know you want to. 😉👍🎸 @boo next will be a 7 string, I borrowed one off someone a week or so ago and really enjoying it. There will be a lot more...

@wayne_f Good video thanks for sharing it with us. I’ve had that fret problem in the past where it goes down on one side. Could it be that the barbed part it too wide for the slot perhaps. I got round...

@markbailey That was probably part of the problem yesterday. Today I had better support but was still having trouble. I figured out what was wrong and how it happened and then fixed the problem. I'll...

Looks to me like you need more solid support underneath the neck to stop it bouncing or bending when you hit it. 🤔

This is My Favourite Song For This Moment....... 🎸🙂🎶🙏

@rocknroller912 Yes they were a set of Hot Slags from Iron Gear, classy!

@tej Are the pick ups a matched set or did you buy them separate from different brands. It might be that the impedance on both is different.

@koendb I think I did check them when I got them but I can’t find a note of the rest so I’ll check that for sure. @robin if the resistance is fine I’ll do that however I read a few articles where peop...

@tej Some sound advice from @robin Maybe also a good idea to measure the DC resistance on that neck pickup. Could be a defect in the pickup too

Annoyingly the neck pickup is really low output, it’s not as hot as the bridge one anyway but the drop in volume between the too is far too significant. So if anyone can suggest a sound approach to di...

Hi, so having built the guitar I didn’t check both pickups before screwing everything down and stringing up etc. Annoyingly the neck pickup is really low output, it’s not as hot as the bridge one anyw...

@rocknroller912 Ah ok so you’re just “drilling” round the screw, thanks for the idea!

@tej There is an easy way to get broken screws out, it’s debated a lot LG guitar forums. Fing a small metal tube just the diameter of the screw (hobby shop or Amazon). File some sharp teeth at the end...

@rocknroller912 Not these ones, the taper was short and I just used a drill bit that’d have been fine for pine and not much else so I can’t lay all the blame with the materials 😬 Just hope I c...

@tej One thing that’s often forgotten is that some screws get thicker along the shaft where there is no thread so thats the part the hole needs to be drilled for. The thread part will find it’s own wa...