I like you're style @bpower , part of the fun of guitar building for me is finding a way to do it. You're next challenge is to add dust extraction to your thicknesser.

Looks awesome @bpower, great job!

There are a lot of tools you can buy for guitar building that would break the bank if you tried to get them all. What I can not afford I try and build until I can afford to get the nice stuff. For in...

Posted by: @ Turned out fine in the end, thanks! 🙂

Very impressive @bpower. 🎸🙏🎶🙂

This is My Favourite Song For This Moment........ 🙂🎶🙏🎸

@robin, with regard to masking the holes, I meant I didn’t do that, not that I don’t intentionally! That said do you know how you would go about this?

I hadn't masked off the bridge post holes when I lacquer my current build @robin ok, so I don’t do that either but I like the solution. What I’m thinking now is to do that to get the built up finish ...

@tej Only concern now is that the bridge is a very tight fit in the mount holes, I hadn't masked off the bridge post holes when I lacquer my current build, so the holes have shrunk with all the lacq...

Currently waiting for my neck blank to be delivered but it should be here in a couple days. I ordered one that's 30X4X4. I'm gonna have to rip it down to two separate 2X4 pieces and then smooth out th...

Again, thank for the welcome - and I'm sure great advice. I'm just about finished my 2nd kit build, I've learned A LOT - some of which I'll go back and apply to my 1st kit and even some of my more aff...

t was a little scary. @boo I’m not putting a reamer anywhere near this build, bad experiences with them, if it comes to it I’ll make some tedious sanding tool and do it very carefully. I’ve some scra...

I’ve somehow missed all of this I’ll not take your previous silence personally @boo 😉 Only concern now is that the bridge is a very tight fit in the mount holes, at least it is in the test on...

making a neck still looks intimidating @stephen Firstly, welcome 🙂 Secondly, please don’t let wood intimidate you! I’d previously put together a kit guitar, finished it nicely and learn how t...

Welcome @wayne_f I hope you enjoy your stay, gonna head over to the showcase to see what you’re up to 🙂

@frank1985 how did you get on?

This is My Favourite Song For This Moment........ 🎶🎸🙏🙂

My version is a piece of MDF with a couple of cheap toggle clamps from Amazon screwed into it 😬 Cheers @tej. 🎶🙂🎸🙏

Here’s a pic of one that does the same, I’ll post a pic of my more rough and ready version later. It’s basically a straight plank with a couple of clamps on, I might have over sold it 🙂 So you...

not sure about others but I used a table saw with a jig I use to square rough planks. Happy to elaborate with picture if it’s of use? Some pictures would be great @tej. Cheers, 🙂🙏&#x...