Attachment : 321E1C27-DBCA-47EE-AA67-3389C708B2D5.jpeg One coat and wet sanded

At last. Ready for strings and final setup etc. so here goes Attachment : 8625F9D8-D8AD-4D60-A753-58B534D1F524.jpeg Attachment : A6A6B84A-C807-4CB4-B4C0-A7BF0742064F.jpeg Attachment :...

@rocknroller912 The Crazy Scotsman is a nutter, very amusing. 🏴󠁧󠁢󠁳󠁣󠁴󠁿🤣🤣🤣🤣

All masked up and ready for gold. 🥇✨✨✨✨🏆 I’ll do this bit with my airbrush, then unmask it and take it into my outdoor workshop for several coats of clear c...

@rocknroller912 Indeed , If I decide to add a layer of veneer, I will have to remove 0.5mm from the top anyway, since indeed, it would make the headstock too thick. I 'll leave everything as is for no...

@koendb I tend to,leave my mistakes as it reminds me for next time.

@koendb That is truly amazing work. 🙌

Today's work:Making a maple heel cap and do a lot of scraping and sanding to get the heel and neck in better shape. Attachment : IMG_20220206_113033693.jpg Attachment : IMG_20220206_1604583...

That does look very nice indeed @koendb 👍

@koendb Woohaaa, brilliant!

I put my logo and tuners on.Not a huge success to be honest. First of all, there where some air bubbles left underneath the waterslide decals, which I did not see until after I clearcoated 🙄 ...

@koendb You will have the strings on soon I think.

Yesterday evening I wanted to setup my saddle routing jig for today, only to realize I had the angle backwards. So I am now able to route saddle slots for left handed bridges 🤣 Ofcourse, I glu...

Neck Carving today! Attachment : IMG_20220204_105437536.jpg Attachment : IMG_20220204_115745605.jpg Attachment : IMG_20220204_125122976.jpg Attachment : IMG_20220204_125154602...

Posted by: @koendb You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and it took me more then 3 hours, The second side , I thinned further down to 2.14~2.18mm an...

Posted by: @russ I've got the sides scraped down to 2mm ready to hopefully bend them by hand next week. You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and ...

Well Peeps. After two and a half weeks weeks of learning how to sharpen and set up the hand tools, then practicing on scrap wood I've got the sides scraped down to 2mm ready to hopefully bend them by ...

Dot is back! but it s now more on the spot where it should have been 😆 😆 Frets installed and I made a headstock plate out of black veneer, 4 sheets glued together and glued to the hea...

Looking good @powerful. Hope all goes well when you get the strings on. 🎸🎶🙏🙂

@koendb Thanks. Slow progress but getting there. Bridge on tomorrow followed by fret levelling etc. Cheers