I've got the sides scraped down to 2mm ready to hopefully bend them by hand next week.
You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and it took me more then 3 hours, The second side , I thinned further down to 2.14~2.18mm and that went a lot quicker ( 20 min )
Success man!
You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and it took me more then 3 hours, The second side , I thinned further down to 2.14~2.18mm and that went a lot quicker ( 20 min )
Success man!
Cheers @koendb.
Apparently we're going to practice with the piece that we're going to cut off to take it down to the right width. Although it will be much easier to bend than the whole side it will give us a chance to develop the technique.
🎸🙂🎶🙏
🗝️ "Life's what you make it"🗝️