@koendb That is truly amazing work. 🙌

Today's work:Making a maple heel cap and do a lot of scraping and sanding to get the heel and neck in better shape. Attachment : IMG_20220206_113033693.jpg Attachment : IMG_20220206_1604583...

That does look very nice indeed @koendb 👍

@koendb Woohaaa, brilliant!

I put my logo and tuners on.Not a huge success to be honest. First of all, there where some air bubbles left underneath the waterslide decals, which I did not see until after I clearcoated 🙄 ...

@koendb You will have the strings on soon I think.

Yesterday evening I wanted to setup my saddle routing jig for today, only to realize I had the angle backwards. So I am now able to route saddle slots for left handed bridges 🤣 Ofcourse, I glu...

Neck Carving today! Attachment : IMG_20220204_105437536.jpg Attachment : IMG_20220204_115745605.jpg Attachment : IMG_20220204_125122976.jpg Attachment : IMG_20220204_125154602...

Posted by: @koendb You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and it took me more then 3 hours, The second side , I thinned further down to 2.14~2.18mm an...

Posted by: @russ I've got the sides scraped down to 2mm ready to hopefully bend them by hand next week. You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and ...

Well Peeps. After two and a half weeks weeks of learning how to sharpen and set up the hand tools, then practicing on scrap wood I've got the sides scraped down to 2mm ready to hopefully bend them by ...

Dot is back! but it s now more on the spot where it should have been 😆 😆 Frets installed and I made a headstock plate out of black veneer, 4 sheets glued together and glued to the hea...

Looking good @powerful. Hope all goes well when you get the strings on. 🎸🎶🙏🙂

@koendb Thanks. Slow progress but getting there. Bridge on tomorrow followed by fret levelling etc. Cheers

@rocknroller912 Thanks. Set up week next week so strings on then. Fingers crossed

@powerful Very tidy build. It’s scary getting strings on for the first time.

Nice work @powerful ! That looks really good

Posted by: @rocknroller912 It looks like you have a good grain match also. So placing the new dot ? Yes, I used the off-cut from the sides of that fretboard, so the grain matched. + I used the piece...

Sorry to all - I had a last minute unexpected obstacle to my participation, so couldn't make it. Well done @rocknroller912 @robin @koendb for managing to get out just before @jamesbisset turned up. S...

@tv101 I did return to the channel and had a nice chat with @jamesbisset.