Posted by: @rocknroller912 Looks like you’ve had a life time supply of bad luck all in one build @rocknroller912 I can honestly say I every mistake has been down to trying to rush something when I s...

@tej Looks like you’ve had a life time supply of bad luck all in one build. This should mean that your next ones will go with no problems.

Posted by: @rocknroller912 I always do a dry run fitting parts before any finishing to avoid things like broken screws @rockneoller912 same here, all the times when things go right, that’s what happ...

@tej Good job I’m glad that it worked for you. Being able to fix mistakes as they happen gives a lot more confidence when building. I always do a dry run fitting parts before any finishing to avoid th...

Some more fancy back masking and it’s now ready for primer, again! Attachment : 1A592D98-FE62-499F-A348-EB693600061E.jpeg Attachment : 67D90A9A-7862-43B9-AD14-BD588BC8E6AF.jpeg Attac...

There is an easy way to get broken screws out @rocknroller912 Worked a treat, Mark suggested the same. If you overlook where the finish is a bit destroyed where I had to twist the pickup mount off it...

Simple little amp - I really only made it to practice my soldering skills. Mini-toggle is a grit-switch (more, or less), following by tone, gain and volume. Drives pretty much any speaker. Sounds p...

I sanded it back today and some spots needed some more filler, just a very thin skim. When this is dry I’ll sand it flat and then mask up for more primer. Attachment : 93690198-3021-4C88-962A-F69...

is it the case you need to build it up slower leaving more drying time? @tej It would probably sink anyway, however I applied it. It’s good that this happens because it shows that things are not quit...

Dug through the wood bin at the school today. Got the OK before I started to "pull out anything you find in there that you might want, I've got enough shit to last a lifetime and these kids don't know...

@tej Crystalac Brite Tone I think you are looking for. I have still yet to try it also.

There are loads of products out there that I still haven’t tried There are more that I haven’t I can assure you 🙂 I’m somewhat limited by not being set up to spray but there are still quite a...

next will be a 7 string, I borrowed one off someone a week or so ago and really enjoying it. There will be a lot more carving, looking into more intricate inlay work too. Also want to make the fretboa...

@wayne_f Good video thanks for sharing it with us. I’ve had that fret problem in the past where it goes down on one side. Could it be that the barbed part it too wide for the slot perhaps. I got round...

@markbailey That was probably part of the problem yesterday. Today I had better support but was still having trouble. I figured out what was wrong and how it happened and then fixed the problem. I'll...

Looks to me like you need more solid support underneath the neck to stop it bouncing or bending when you hit it. 🤔

@tej Use a bit of bees wax on the threads of your screws to lubricate them and they will go in much easier. 👍

Mr Talisker visited @tej A very nice dram indeed. 🏴󠁧󠁢󠁳󠁣󠁴󠁿🥂

@wolframmalukker First of all, welcome to our online community of guitar building. I’m looking forward to watching you build your electric ukulele, it’s something I’ve been thinking about building fo...

Thanks guys. I just dropped off the CAD model at the print shop, so that I can have full-size prints made. I just finished up teaching Blueprint Reading so my students have "A" size prints in hand now...