Nice work !! Thanks for sharing the pics 😎 

Don’t go tightening the truss rod it after you glue the fillet or it will bend and break the fillet! Also – when the fretboard is glued on the neck will be far too stiff for the truss rod to…   Read more»

Thanks to everyone for chipping in – good Q!…Short answer – It’s OK. 😌 Some things to consider: The Aluminium part does look like it could sit squarer…make sure the round bar is fully in the hole – you might…   Read more»

The drawings should be printed on A4 size – sorry for any confusion…I will check out the typos you mentioned…where did you download the plans from?

You can dry clamp the neck to mark and drill the bridge holes – just make sure to double check alignment as you are gluing. You can run a ruler down each side and check it intersects with the bridge…   Read more»