Welcome along

That’s the neck glued in and post holes done, stil a bit more sanding then onto finish.
 

Frets all levelled, crowned and polished. Side markers done, everything sanded to 240 grit. Something went slightly off somewhere so the neck angle ended up a bit off so I made a shim that goes from about 1mm to nothing….   Read more»

The method Mark uses for carving the neck is so quick using mahogany, took me less than an hour to crave the neck, heel and do the volute. Got the frets in earlier before carving.
 

Got the fretboard radiused and markers in, 6mm aluminium tube with sawdust and superglue. Get the frets in tomorrow
 

@tv101 No no, I got the trussrod and headstock plate off it lol

Crack goes all the way to the floyd cavity, you can bend the neck and feel the body move lol
 
This one is firewood! 🤣 

Well bollox! I knew the neck was tight but only just realised how tight! Gone and split the body! 🤣 
 
Think I’ll put this one on the back burner pile for now lol
 

Glued the neck in today then this evening I thought I’d check how it all looks. Well that’s a relief!
 
Now onto more finishing.
 

Got the carve done today and the recess for the controls, after a lot of sanding I wiped down with white spirit to have a look. Looks awesome!
 

Well this has progressed, body cut out, pickups and control catvity routed, belly carve done and neck on it’s way to being done. Tomorrow I’ll be carving the top, mostly filing due to the knots lol
 

Carves sorted, frets levelled and polished, fretboard oiled and now the body has finish applied. Next will be to mask up around the pocket and glue the neck in, then mask the body and get finish on the neck.
 

[Read more]