Hi Peebee body shape is the tough bit, well after the headstock of course Thats the headstock designed now. Attachment : 20201217_175358.jpg

@Peebee Are you actually going to turn this into a guitar? Get it done, there's nothing wrong with an old bit of pine. The huge knot in mine is now a feature.

Ok, I’m bored with band-sawing now!! 95 chair backs later I’ve had enough! I know they’re not guitars, but if I’ve been a bit quiet in the forums over the past week or two here’s one of the reasons wh...

It’s about 4 pieces of scrap pine dug out of the shed glued together. @peebee Nothing wrong with that. As far as the knot is concerned, you could reinforce it with epoxy.

(I'm an NHS nurse btw so apparently I get extra dibs on Lucy!🤣🤣🤣🤣🤣 - even though the whole world is struggling to survive, small businesses are being killed, th...

Vintage wiring Vintage or 50s wiring on the tone pot will keep your rhythm sound clear as you wind down the volume. I hate when a guitar begins to sound muddy as soon as you lower the volume control a...

Attachment : 20201216_172501.jpg Here's the start of build #002, a big blank sheet of paper. Still trying to decide what body shape to go for.

Body shape decided and 22 frets. Attachment : 20201216_193913.jpg

Proper Job M&C! Loved watching the re run of today's livestream after work tonight (I'm an NHS nurse btw so apparently I get extra dibs on Lucy!🤣🤣🤣🤣🤣 - even...

Had a go at a belly carve today on a scrap wood tele body that I have made as practice. Turned out pretty well, draw two lines, make two facets and join em up...simples. @peebee Excellent! It’s not t...

Nice work ! Goes to show that you don't have to spend a fortune on wood to have excatly the same amount of fun ? Where did you get the offset heel plate? Maybe you could have carved the heel of the n...

This project started off as a bit of a joke to see how cheaply I could make an electric guitar but it’s actually turned out well. The body is made from reclaimed pallets and I cheated with the neck a...

So for my 2nd home build i thought i'd try some binding and purfling, but didn't want to fork out for a bending iron. Turns out my wife's curling tongs are just the job and cost me nothing - other tha...

@peebee Thanks, yes I like to have the integrity of the ash body stand out with the pink. It shimmers with the open grain and not look like a novelty per say. Ties in with the dyed and lacquered maple...

All done. She is packed up and getting picked up by courier in the morning, destination Scotland. 🏴󠁧󠁢󠁳󠁣󠁴󠁿 Attachment : 656189B5-DE21-405F-8D...

A Telecaster build for my niece Although I made a bass with a premade bolt on neck, this was my first attempt into making a Fender style bolt on neck, following the bolt on course with modyfying the a...

The internal radius on all corners is 5mm OK. 1/4" is 6.35mm. So that’s gonna be too tight. 3/16" is 4.76mm (and a bee’s bollock). So 5mm sounds pretty much perfect for that ‘sharper’ P90 profile. ...

Always cock up before you ask for help, that helps to reinforce the lesson learnt.

If only I could lay my hands on some kind of cross between a chisel and a knife. Small flush-cut saw? One of the Japanese things that Rutlands sell perhaps? like this chap ...