This is My Favourite Song For This Moment..... 🎶🙂🙏🎸

now with a small chip too so I’ll need to reprofile the edge and wrap the headstock with something to protect while I carve the neck. I gave up caring about tear out and small dings and chips, caus...

This is My Favourite Song For This Moment....sing along now. 🎸🎶🙏🙂

Being a tool junkie I bought a very nice carbide scraper burnisher from Workshop Heaven, but it seems you can use pretty much anything that's hard enough.

I forgot to install the side dots Side dots: check! Attachment : IMG_20210528_141250159.jpg

Took it down a little thinner than planned, as the tape slipped and I didn’t notice until it was too late, thankfully didn’t go through the veneer but it was pretty close!!! Attachment : E3A3F4E6...

Front laminate done, no slipping during clamping so the truss rod slot is nicely aligned 🙂 Now to trim and thin it down, a lot!!!! Attachment : FF385C3E-05CB-406E-ABDD-4BC4CB1B4327.jpeg ...

And it is DONE! Ah no it isn't .. I forgot to install the side dots ! So still one little job to do ( and a proper fret end dressing, I couldnt be bothered at 3:00 am this morning ) 😉 Color i...

Beauty

Routed the truss rod slot on the front headstock veneer and glued it on. It’s really thick and I want it at about half a mm so I’ll surface route it to thickness on the neck angle jig when it’s dry. G...

Hello everybody,I'm Daniel and I'm a guitaroholic 🤣 Just joined the forum, wanted to say hi and then ask a question. I want to start an electric guitar build, my first one.I've already purchas...

As thin as 5mm. From fretboards to acoustic tops. Attachment : FullSizeRender.mov

Quite useful if you do not have the proper bandsaw. Takes a long time but works great Attachment : IMG_4085.MOV

Hi I made a frame saw based on a Tom Fidgen design specifically for jobs like this.

It all looks very neat even the bit you said is a mistake @rocknroller912 thanks, did I say it was a mistake, they’re erm, internal tone voids to create a resonance cascade that will enhance the vibr...

Got the fillet sorted, had to make a custom one to cover up where I’d routed the slot too wide. There are still two thin gaps where I screwed up the slot even wider but that shouldn’t be a problem. Un...

Attachment : 189505870_3968027873275072_7476630823469183375_n.jpg

This morning I experimented a bit with a decal and with stain colors on the neck and a piece of the leftovers body blanks.Goal was to match:1. The colortone of the example picture I 've added in the f...

Reach for the sky Louis and don't forget to look back once in a while to remember where it all started. @boo I promise, i will 😉 🤗

Would this pic be annoying enough??? @steveadams You bastard! 😆👍🍻 Enjoy