Then a wee bit of sanding.

🙏🎶🙂🎸

Then plane and scrape it flush with the sides.

🎸🙂🎶🙏

Then cutting it to size.

🙏🎶🙂🎸

Then glued it in place.

🎸🙂🎶🙏

Then I made the end graft from a cut off from the neck blank and two pieces of ebony veneer. 

🙏🎶🙂🎸

A wee bit of work on the end graft. Once it was marked out I gouged out the channel using chisels and “Grannies Tooth” 

🎸🙂🎶🙏

Then I used the router and binding jig with a flush cut bit to trim the back and soundboard flush with the sides.

…….. 

🎶🎸🙏🙂

Then I glued on the soundboard using the go-bar deck again.

🎶🎸🙏🙂

Then I marked out and cut out the notches to accommodate the braces of the soundboard.

………

🙂🙏🎸🎶

Next I cut out the notches in the kerfed lining to accommodate the back braces ready to glue on the back of the guitar.

Then glued on the back using the go-bar deck.

Then sanded down the inside…   Read more»

Then finished off using a sanding stick.

……..

🙂🙏🎸🎶

Then gouged out using chisels.

🎶🎸🙏🙂

I cut out the edges using my Japanese saw.

🙂🙏🎸🎶

Next I marked out the dovetail.

🎶🎸🙏🙂

Good to hear from you @boo.
🙂🙏🎸🎶