@koendb I’m sure Mark did a live stream on neck through construction.

Ok if it’s too quiet I’m up for stirring the pot. I challenge you to cut those horns with a router.

I’m not familiar with the approach for neck though, at what point do you join the wings on to the neck? @Tej I don't know yet. This would be my 3th scratch build and first one with a neck through.Thi...

Hi Bpower. Is it a tight fit around the heater nozzle and also is the opposite end of the pipe closed off at all. Thanks

He just commented he might want to go for the same colour as his AC Cobra replica, which I can see working. @jonhodgson If you get me the colour code of the car, I can paint the guitar in the exact s...

This isn't for me (I want to try my hand at finishing my own) but a friend of mine has a Fender Jaguar that is now looking a bit worn and he just asked me if I had any idea what it would cost to refin...

@powerful . I just used a pipe and a heat gun. I got a 1 1/2" pipe that would fit over my heat guns tip. Put a bracket on in so I could clamp it in my vice. It is pretty low tech but it worked for the...

@steveadams Your videos are never boring, and since I got a new iPad I can even get them on full screen.

@powerful Pints certainly do come tonight, after a long motorbike ride in the sun I’m ready for a few.

That’s point taken mate. The pint comes tonight

Sound advice Rocknroller much appreciated. As I say it’s all pie in the sky at the moment but worth thinking about. Thanks for your input on this pint taken. Cheers

@powerful It could work however too much moisture can cause a ripple effect across the wood as the steam is absorbed differently by different parts of the grain eg flame maple where there is light and...

mighty quiet in here of late!? Yes it is really quiet the last couple of weeks. I guess life is catching up again 🙂

Yes Tej me too which led me to believe that directly introducing steam would simplify things a bit. I know people use steam boxes so maybe this would give similar results. Again I'm only guessing and ...

I think I might. It seems plausible to me but I really have no idea. Hopefully someone will stop me making a catastrophic error before I jump straight in (which is what I usually tend to do). If I can...

@powerful it is at least worth the experiment!

I think that you should try it out for us all @powerful and let us know how you get on. 👍😁 🎶🎸🙏🙂

Hi. Looking at all the ways to bend a accoustic side and watching Marks' youtube video, it appears that the fundamental thing to bending is the creation of steam. So if this is the case, would a pipe ...

V2: Correct Bridge and angle slightly lowered into middle section Attachment : NeckTrough-2.png V3: Hump in bottom half of the body slightly removed Attachment : NeckTrough-3.png V1, V2 ...

This is My Favourite Song For This Moment........ 🎶🙂🎸🙏