Flattened the clearcoat on this pink thing yesterday, did a little bit of a graphic with my airbrush and re-clearcoated. I’ll leave it for a few days and then flatten it again and put a few more coat...

Looking good @jmcmi93888 🙏🎶🙂🎸

Attachment : steppedplates.jpg Today's offering is the front and back (planed to 17mm thick) with the perimeter reduced to 5mm using my router in a stand and carefully running the edge past the bl...

The carbon truss rod is purely a stiffener 4mm wide x 7mm deep as I am unsure of the potential for elm to flex even in a short length. I am thinking about 22mm thickness at the nut as well . Too much ...

A pleasure to watch @clinton. 👍😁 🙏🎸🙂🎶

Attachment : IMG_4280.mp4 Taking way too long. Time to crank up the volume to 11!!!

@tej Tested my new bushing and pin cutting out the sound hole. It works much better. I know Mark uses a big router to cut these inlays but I wasn’t using a standard 6mm inlay only a DIY one from a bit...

Hey @darrenking. I just wanted to let you know I am really impressed with the slot cutting jig. The quality is very impressive. Can't wait to start making my own fretboards. Great design, and being a ...

Thanks @markbailey. I have not carved the braces. Will carve them the day I'm ready to glue it on. I will keep the clamps on it though to help prevent as much movement as I can. 🙂

Storing the back - TIP! After gluing the braces on to the back you should not carve them until you are ready for assembly - If you are leaving it for some time there is a danger of it changing shape.....

All looking Great @bpower. 👍😁 🎶🙂🎸🙏

Looks like I’m in trouble, my bike mechanic workshop and my guitar workshop are the same place.

Just to clarify for the newbies (and bike mechanics😬) - Your common or garden oily rags and guitar workshops don't mix. 😲 We don't have normal oily rags as they are dirty.🤮 or ...

This is My Favourite Song For This Moment......a few years ago now 🎶🙂🎸🙏

Decided to get the back ready before the front. I have it at the point where it can wait for the front and sides to be done. Left the braces thick. Ill carve them right before I am ready to put it tog...

I'm on the east coast of canada @darrenking. Still decent temperatures here. I was raining and chilly the last few days. I do not envy the west coast of canada right now with the heat and the fires. I...

Looks like you’ve bought some great products there BPower! I took delivery of some soundboards from NW Canada only last week and I really hope you’re not in one of the stupidly hot regions, doesn’t lo...

@jmcmi93888 looking good. Slow is good (fast too) 🙂

Attachment : plates.jpg Progress has been slow. I now have the back and front plates planed and bookmatched as best as I can given the fairly open grain. Attachment : neck.jpg Also the neck...

There's no fish oil in it, that's an urban myth that's actually mentioned on their website "Myths and Fun Facts" page. The exact formula is a secret, but between the information they have to provide o...