no problem and I meant to respond. It’s just been a busy weekend, I’ve had sorts of odd people drop in!!😂😂😂 Yeah I gathered you’ve had a busy one. Yeah there are all kinds of ...

Oh I got the buffing mops on Friday by the way (I sent you a text) Hi Boo, no problem and I meant to respond. It’s just been a busy weekend, I’ve had sorts of odd people drop in!!😂😂&#...

The only downside with making it taller That said, it is easier to add a riser layer to the bed of the jig to bring thin material closer to the cutter than it is to raise the height of the rails.

that cutter is 52mm This is a great cutter and I love Wealden products, and I think they offer the best value for money of any UK brand. My only concern is that this is quite a big cutter to be using...

My existing set-up uses a 50mm rail height. The only downside with making it taller is that, if you also need to flatten something thinner, then your router bit might not be long enough to reach A v...

So should I go for a compromise of 55mm as standard to accommodate neck blanks?

It all looks good to me @darrenking it will be good to finally have a purpose made, flat surface routing jig. I always have confidence in you creations. Oh I got the buffing mops on Friday by the way...

I need to get out of these suspenders And I need to get that image out of my head!! 🤣 🤣 🤣 Ok, here we go. There may be a couple of minor changes for the production version bu...

there is nothing to stop a narrow blank being held diagonally I had thought of that after commenting @darrenking but wasn’t sure if it was a whack idea or not. So I guess it isn’t! 😆

I’m guessing a bit more clearance may be a good idea. OK, I’ll increase it to 60mm and if anyone finds that this it too high then they can always trim the rails down a little bit themselves. Sound li...

maybe this is just designed for body blanks? Hadn’t thought about neck blanks. I could add about 80mm to the length without it too much of an issue and there is nothing to stop a narrow blank being h...

I think it looks great @darrenking! The height of 50mm sounds good but perhaps it’s right on the edge? Most body blanks end up around 45mm but depending on how thick it is before planing, it could be ...

@darrenking. We'll Darren, to my now semi trained eye, I think it is fantastic. I would imagine that 50mm is deap enough to do the job but I don't know why but something in the back of my head is sayi...

Apologies for double posting but I thought I should probably post this under its own topic rather than hijacking TV's heading. Ok, here we go. There may be a couple of minor changes for the producti...

Just a couple of teasers! @darrenking. Hurry Darren. I need to get out of these suspenders. 😂😉 🙂🎶🎸🙏

@tej Sounds like it will be ok. I don’t use a lot of machines but cleaning sticky wood residue is the same on any tool even a hand saw, so if it does that no worries. I only use silicone on parts that...

Any parts the you might want to glue or finish will be affected by residue from lubricants. @rocknroller912 that was my main concern, this one states that it’s not silicone based and doesn’t Mark or ...

@tej Are you thinking of any particular brand ? I’ve used Lubo Wax which is petroleum based but now I use silicon grease spray for lubricating machine parts as it’s not greasy, dries and wood dust doe...

Morning all, do any of you have experience of using machine wax on bandsaw or table saw beds? What’s your verdict if you have?

A compressor is a wonderful excuse to buy all sorts of other tools, including a venturi bagpress unit. Hopefully I can avoid getting one though, since we have a couple at my hackspace (including a ver...