Listen to MSG, got it...

MDF not msg

Cheers @tv101 its 18mm msg with a couple of 1x2 pine rails. Ive just got a very similar bit but it’s good to know decent places to buy from. 2mm is too much, that’s great, that’s definitely where I’ve...

Well then @boo maybe you should lay off the imported candy paint, What are you talking about Matt? To paraphrase the ‘Kingsmen’ ‘Glitter, sparkles and shiny shit maketh the man!’ Leave Boo be and ge...

Must be very satisfying@robinwhen a repair job works well. @russ It definitely is satisfying. After cursing myself for stupid errors or accidents, I quite enjoy the "fixing things" aspect of guitar...

Must be very satisfying@robinwhen a repair job works well. @russ It definitely is satisfying. After cursing myself for stupid errors or accidents, I quite enjoy the "fixing things" aspect of guitar...

Yes @tv101 an echo....

@lemonshoes To route a binding channel there has to be a reference point for the router guide bearing ot a straight edge to work from, so I don’t know how you would get this unless you finished the ne...

My thinking on the process was something like this: Route binding channel Install/glue binding on the neck Use fret tang nippers for cut the excess binding height above the fretboard to get it relativ...

@lemonshoes Forgot to say, if it’s your first build undercut frets are hard to do and it’s easy to spoil the binding. Are you planning to cut them to length first or file the edges after installing.

@lemonshoes I think if you installed binding on a non radius fretboard and then tried to radius it the binding would probably get damaged. For installing undercut frets on a radius FB my steps would b...

Hello, I apologize if this has come up before. I did a quick search but didn't find anything. I have a nice chunk of Black Limba which I'm planning to use for an LP style body. I'll likely be orde...

So here I am to learn and hopefully avoid many a costly mistake! @tej Hey man, welcome to the forum and get ready to learn some guitar building tricks. You should also get ready to make lots of mista...

Welcome @tej. I'm sure you'll have some fun on this forum and building your guitars. Cheers, Russ 🙏🎸🙂🎶

Hi everyone, I stumbled across this fantastic site while looking for info around guitar building advice. After finishing and constructing a cheap kit guitar and being pleased with the results I’ve dec...

@markbailey Only when you are ready. It’s good to know you are keeping busy though. 👍

Take it easy Mark, all in your own good time.

Glad things have stabilised even a little is definitely something positive. Take care all of you

Glad to see that you will be back soon. Watch out for Mark & Carol the video game, it’s under discussion.

@markbailey. Great to see you again Mark. Hope all is well with you. Looking forward to you getting back. Take care, Russ 🙏🎸🙂🎶