Last seen: Apr 17, 2025
Nice One!
Rough Neck
Bodybuiding
@nsj gorgeous!
@russ top job!
Are the gouges deep? Be mindful that when you carve the neck that it does not poke through. You pretty much have 1/8-3/16 of an inch thickness left af...
Back at it
You are good on track
That’s great. Yes start with a TOM. Get that under your belt first.
Nominal routing depth for neck pockets for fender style bridges with 21-22mm thick neck blanks, 5-6mm fretboards. Start off at 16mm neck pocket route ...
Here is a tip. When in doubt we are here for you. Correction In the video I said 22mm thickness on my neck blank but it is actually 24.5mm.
@kalimar If the piece is long enough, you can cut off a piece to glue to thicken headstock or do a scarf joint. It is done all the time.
@kalimar surely can. With P-90s you are gonna need a smaller diameter flush trim bit and with fender style bridge, no neck break angle but completely ...
@jamesbisset The cutaway is not quite cut yet. Major but Minor adjustment it seems like and it is your only recourse with a slight adjusting of the hu...
Laminated Koa Bodies
Neck pocket templates
Welcome to the builds. It does not disappoint. It is very gratifying!
Short Scales