Copyright is not something that could apply in this case. (same as the Fender headstock, that's protected as a trademark)It seems that the link times ...

Excellent, thanks!

Thanks Interesting, what's your method for cutting the slots (seems a bit narrow for a router)?

Not copyright, trademark. And it's the arrangement of the tuning pegs. I don't know how specific the protection is, that's probably down to a court ...

It's a registered trademark and they enforce it. You might go under the radar if you were just building for yourself, but having read the response o...

It's a mystery to me why so many musicians don't understand copyright. It is not possible to copyright anything, it's not a process, it's a statutory ...

The only thing I've received this Christmas was a card.. from a dog.. that I've never even met! (I sponsor him at the Dogs Trust).I know my brother go...

You can get Angelus Leather dyes on Amazon.If you're not familiar with them don't be fooled by the name, just watch some videos by Big D guitars on Yo...

@james-chacewatergmail-com-2 For your 12 string project, have you planned to do anything different with the bracing, or do you think what you did on ...

@darrenkingTwo reasons1) My goto guitar is always going to be the one with the cutaway, that's just the way I am. I'm a 24 frets on an electric type p...

I'm looking forward to the finishing course (that guitar was as good as anything I've seen and better than most final reveals in "how to finish your g...

Somebody I know (from my local hackspace) has been setting up a workshop in a shipping container. He's renting a patch of land on a farm I believe qui...

@markbaileyI was looking at the existing threads on it, where people asked the question when it would be available! Been a bit busy to watch livestrea...

Did I miss a post saying that this jig is now available in the shop on this website?Because it is

From the fact that you wrote "low odour" I'm guessing that this is Solarez's "I can't believe it's not lacquer"?That's very hard to get outside the US...

I think I'll be taking your advice and buying one.But after your bit about the masking tape for the centre line, my first thought was "why don't they ...

@darrenkingYour CNC may let you specify hole positions to the micron, but I'm pretty sure it's not placing them that accurately. Not even a Kern Milli...