@koendb Thanks! I will try to decide tomorrow. No more saw dust today...

@boo Yes, several times 🙂 Right now a hair over 21mm and 23mm.

Finally started to carve the neck, but is a bit stuck at "refining facets". I have made the "third" facet, the flat bit on the back. Now I don't kno...

@markbailey @bpower Thank you! No need to panic then, since it is easy to press it flat. We have experienced cold and dry weather in Sweden for a ...

This one, often.

@rocknroller912 Side by side, so the joint would be on the centerline. That will allow for two necks with enough thickness. Might be a little tight wi...

@rocknroller912 Where the neck meets the body. It is thick enough in the other areas. Would the strength be compromised if an extra bit is glued o...

@russ Thanks! I will try to post some pictures of the progress.

@boo Thank you. A lot of good advice, and you point at one of my biggest challenges - I want to see results quickly. This time I will try to go for...

Sounds fair. Don't want to make the fretboard more fragile than necessary. Wood is expensive. 🙂

@koendb Thank you! I'll start with a double-cut inspired by the Bandsman. Two pickups and 24,75" scalelength.