@robin ah that could do it. I'm not actually sure where this bit is needed, I'm just going by the essential tools list pdf. However; this should be close enough I guess. Thanks.

You're likely to use that trimming the first few cuts on a body blank to a templated shape or a cavity from a template.

@russ that's brilliant, thanks 🙂

@nortski
I think they're pretty much the same but they tend to refer to the straight cutters as trimmers and the shaped cutters as profilers. In saying that if you're following a profile with a straight cutter then it's a profiler. 🤣🤷🏻‍♂️

lol ok understood, thanks 🙂