Nominal routing depth for neck pockets for fender style bridges with 21-22mm thick neck blanks, 5-6mm fretboards. Start off at 18mm, check to see where you need to go route deeper 0.5 to 1 mm at a time to attain…   Read more»

Here is a tip. When in doubt we are here for you.

@kalimar If the piece is long enough, you can cut off a piece to glue to thicken headstock or do a scarf joint. It is done all the time.

@kalimar surely can. With P-90s you are gonna need a smaller diameter flush trim bit and with fender style bridge, no neck break angle but completely straight with neck string height of 11.5-12mm as opposed to 16mm for tune o…   Read more»

@jamesbisset The cutaway is not quite cut yet. Major but Minor adjustment it seems like and it is your only recourse with a slight adjusting of the humps.

Laminated Koa Bodies

Neck pocket templates

Welcome to the builds. It does not disappoint. It is very gratifying!

Short Scales

Surely can do. A radius dish and go bar clamping would make your life so much easier.

Welcome to the builds. Savor the journey and enjoy the outcome.