@steveadams
Your videos are never boring, and since I got a new iPad I can even get them on full screen.

@powerful 
Pints certainly do come tonight, after a long motorbike ride in the sun I’m ready for a few.

@powerful It could work however too much moisture can cause a ripple effect across the wood as the steam is absorbed differently by different parts of the grain eg flame maple where there is light and dark. Thick gloves are…   Read more»

@tej 
It was a new Dremel bit straight from the packet. Likely the very soft wide grain wood.

@steveadams  I have to agree with @bpower it’s hand made so there will always be things that show this especially on a first build. Regarding blemishes on the white, is it worn through or dirt which has stuck with super…   Read more»

Good thing this is only a practice on cheap wood as it didn’t go too well. I got some bad tear out around the outside edge and had to do a fudge with violin purfling. Definitely going to be wall…   Read more»

@tej If it’s got side adjustment it sounds like a plan but I’m not an electric guitar expert. If your neck is a tight fit there shouldn’t be much difference between the test fit and the final. I can see…   Read more»

@tej
What type of bridge do you have. If it has some intonation adjustment that should take care of any small changes after the neck is glued.

@tej  Thanks for asking, I’m still working on it. I had a router malfunction of course possibly due partly to operator error but partly not. I found that the centre pin on my Dremel circle cutter was very slack and…   Read more»