Cheers @boo, I only have stain as opposed to paint and no spray gear. The potential for making it worse is definitely there if I do try to “fix” it 😬 Anyway, who told you about the drill bits ...

@robin thanks for the feedback! Unfortunately the glue is in the grain a little too so I’m not convinced either will actually work, why I didn’t mask it before glueing is beyond me 😔

@koendb thanks 🙏 I checked around the join, there’s a gap (😔) on one corner where I’ve not fully seated it in the pocket on one side, I’d need a feeler gauge to measure it so it’s smal...

@russ I’ve used tools from a variety of companies, ones I’ve had from Crimson Guitars are my favorite. They’re expensive but a delight to use and so far have been totally happy with them!

@irishwhiskeycoke Hey, so my current build was all done with an Aldi bandsaw, the only Aldi power tool I’ve had that’s not died or tried to kill me. I replaced the blades with ones from which have be...

@whyte Welcome Pete, strongly suggest you marry your girlfriend, if you lock that in now before you fill the walls with guitars it’s more likely she’ll stay 😉😋 Looking forward to seein...

Finally after finishing, having to sand back and re-apply the finish I have the neck in. Now, one of us, let’s say me, seems to have left a thin coat of glue residue where the heal of the neck joins t...

I’ve used a round file before. I use a really fine, thin, round file @boo I’ll have to look at the type of file you’re talking about, I have a half round mini file that might to, between that, @rock...

clean out the finish build up from post holes by running a sharp knife carefully round the inside @rocknroller912 thanks for the idea, i think the initial layers will be cured hard by now, I can test...

One thing I would advise though is that you mask up the neck pocket at least, @boo yeah I figured that a few coats in, masked it up and then started removing it between coats as it was building up a ...

Progress on the body finish Attachment : 14C657EB-30F3-4520-9B4C-DB394F56A706.jpeg

@robin, with regard to masking the holes, I meant I didn’t do that, not that I don’t intentionally! That said do you know how you would go about this?

I hadn't masked off the bridge post holes when I lacquer my current build @robin ok, so I don’t do that either but I like the solution. What I’m thinking now is to do that to get the built up finish ...

t was a little scary. @boo I’m not putting a reamer anywhere near this build, bad experiences with them, if it comes to it I’ll make some tedious sanding tool and do it very carefully. I’ve some scra...

I’ve somehow missed all of this I’ll not take your previous silence personally @boo 😉 Only concern now is that the bridge is a very tight fit in the mount holes, at least it is in the test on...

Here’s a pic of one that does the same, I’ll post a pic of my more rough and ready version later. It’s basically a straight plank with a couple of clamps on, I might have over sold it 🙂 So you...

@frank1985 how did you get on?

making a neck still looks intimidating @stephen Firstly, welcome 🙂 Secondly, please don’t let wood intimidate you! I’d previously put together a kit guitar, finished it nicely and learn how t...

Can I ask how you managed to make an accurate neck taper template? @russ not sure about others but I used a table saw with a jig I use to square rough planks. Happy to elaborate with picture if it’s ...

Welcome @wayne_f I hope you enjoy your stay, gonna head over to the showcase to see what you’re up to 🙂