@boo I must admit, I am no fan of glitters and flakes but your skills are amazing

@swepri, wow those facets looks clean! Man you should see mine 🤣 You can now decide where you want to go with this. If you mark your next lines nea...

@powerful Ahhh nice work man! That looks amazing.

@Boo wow! Nice!

@Clinton Those are gorgeous! 😍

@rocknroller912 Indeed , If I decide to add a layer of veneer, I will have to remove 0.5mm from the top anyway, since indeed, it would make the headst...

Today's work:Making a maple heel cap and do a lot of scraping and sanding to get the heel and neck in better shape. A Quick simulation with ...

I put my logo and tuners on.Not a huge success to be honest. First of all, there where some air bubbles left underneath the waterslide decals, which I...

@clinton I love Tele's, I will sell one of my tele's I bought , just to have an excuse (and more importantly: more space ) to build another one 🙂

@clinton I still cant see the videos here on this forum, but I am able to download them , then watch em with Quicktime Player on my mac. That Junior l...

Yesterday evening I wanted to setup my saddle routing jig for today, only to realize I had the angle backwards. So I am now able to route saddle slots...

Neck Carving today! Perhaps I need to revisit the heel , but other than that I am happy with the result. It took a lot less energy then wit...

You got this @russ . Just make sure they are thin enough.. My first one was about 2.4mm and it took me more then 3 hours, The second side , I thinned ...

Dot is back! but it s now more on the spot where it should have been 😆 😆 Frets installed and I made a headstock plate out of black veneer, 4 sheets...

Yes, I used the off-cut from the sides of that fretboard, so the grain matched. + I used the piece that was between the same frets, so I only had to l...

Nice work @powerful ! That looks really good

@tv101 I did return to the channel and had a nice chat with @jamesbisset.

Only two of them... (*bada boom tsssssss*)

Success!! What dot? when dot? where dot? No superglue needed 🤗 First attempt ( = beginners luck? )

@rocknroller912 After our conversation yesterday, I decided to try and fix this dot after all. So this morning I made a jig to guide the dremel and ...