@sogoslotvvip I used chrome and abalone to brighten it up. 😁

Well I didn’t think using a spoke wheel truss rod would be that easy. I was thinking more on the lines of having to drill end to end through the neck ...

@nsj thanks

“ Ps using a floyd is a good reason to use a spoke wheel trussrod, less busy at the nut” Good suggestion but yeah, naw. Not yet anyway. More things to...

And here’s where I am at the end of today. There’s a few spots I have to touch up on the back then I’ll be ready to start shooting the clear. That’s 2...

Started working on the finish last weekend and I’m spraying the back now. Hope later today to shoot the front of the headstock and a small 1/2 inch bl...

Well I usually set the pickups about an 1/8” below the strings when pressed down at the last fret (22/24). The main concern is how deep to route the e...

Uhm, 🤔 anyone?

Mine is the DJ6. Here’s an Amazon link from the app. Sorry it may come up in the US store so check that if you follow the link DAJA DJ6 Pro Laser En...

@nsj yeah I suppose if you’re only using regular pots but I use push/push these days. Did use push/pull but switched earlier this year. I do all the w...

Y’all talking about soldering and all but have any of you seen these? Clear heat shrink loaded with a small ring of solder in the middle. Stick your w...

@markbailey also, I used fine mother of pearl dust and wicked CA into it then sanded it and the abalone dots down. It’s a really thin stroke on the lo...

@markbailey MARK! Yes my mentor, I forgot to mention that detail. Apologies. A couple of months ago my laser engraver arrived. I bought it in 202...

What’s it have in it for shielding?

@wolframmalukker 😳 😳 😳 wow, uh no I’m not kin to either of those that I know of. In the BG area, I’m kin to Runners & Richards (😂 R&R 🤣). My...

@wolframmalukker hey hey!!!! I’m actually a bit farther east and about 80 minutes from BG. I live very close to the geographical center of Kentucky....