Great start @tyreman. Keep those pictures coming. 🎶🙂🎸🙏

Then I bent the sides into shape using the pipe bender. I then held them in place in the guitar mould. 🙂🎶🙏🎸

Then plane the edges flat on the shooting board. 🎸🙏🎶🙂

Then cut into shape on the bandsaw. 🙂🎶🙏🎸

Onto the sides now. I used cherry for the sides on this one. Planed and scraped down to 2.0 - 2.1mm thick. 🎸🙏🎶🙂

Excellent repair job @koendb. Toolbox? 🤔.... there's an idea. 🙂🎶🙏🎸

I do like that fretboard @nsj. 🤌 🎸🙏🎶🙂

Cheers @koendb. How's your build coming on? 🙂🎶🙏🎸

@rey_rchotmail-com Welcome Rey. Enjoy the ride. Hope you don't get too much sawdust in your dinner. 😂 🙂🎶🎸🙏

Then I carved out each end of the centre strip to accommodate the heel block and end block. 🙏🎸🙂🎶

Time to carve the back braces into shape. 🎶🙂🎸🙏

Then glue in the four back braces. 🙏🎸🙂🎶

The next stage was to mark out each of the areas of the centre strip where each of the four back braces will pass through. Then carve them out 🎶...

Your putting us procrastinators to shame @nsj. 🤣😂 🎸🙏🎶🙂

@peter-c-f Keep us posted Peter. I'm keen to have a go at this. 🙂🙏🎶🎸

I'm the same @swepri. I just borrow other people's ideas. 🤣 🎸🎶🙏🙂

Cheers @swepri The shooting board has a series of holes at even intervals along the length of the board. I think mine were set at 8cm apart and abou...

......then glued it onto the inside of the back 🙏🎶🙂🎸

I used an off cut from the soundboard to make the centre strip for the back 🎸🙂🎶🙏

Then I cut out the shape of the back 🙏🎶🙂🎸