More routing and rounding, also have the holes for the wiring, socket and strap pins done (no pic of that bit!) Onto carving next, happy days. 🙂

RoutyMcRouterson I use a bit from radian tools, really not impressed with the cut from it, perhaps I took too much off in one go. Fairly sure it...

@rocknroller912 Absolutely, I think a lot of what I’ve done will be used again though 🙂 At least it will if I have my way 😬 The effort for most jobs d...

@rocknroller912 I like that idea too, it does however presume I’ve got the sides even 🤔😉 I’ve got to remake the neck pocket template anyway after so w...

@rocknroller912 exactly the same as the one I’ve made but the back of the template would go to just before the edge of the body past the bridge. If I ...

@rocknroller912 Thinking about alignment I’m contemplating extending the template to the length of the body pretty much so that way I’ll get the smal...

After a few failed neck pocket template attempts, I made an adjustable jig for making the pocket template from based on a design posted previously on ...

@blake looking good, great job!!

I’m counting on this being true 🙂

@jonhodgson that makes sense, where I didn’t screw it up the superglue has worked perfectly and I would tempted to go the same route again but I seing...

@jonhodgson now isn’t that something you’d loved to have stumbled across in the past 🙂

Side dots all done, 1.5mmx1.5mm MOP, most awkward part of the build yet. I’ve drilled one of the holes for the 24th marker out of line, thought it was...

@jonhodgson yes I’ve been warned about that before, no idea how likely it is to actually happen but not worth the risk to find out !

@hursty just measure it so you know where you’re at when carving. If it helps you can always mark a line before you carve the back of the neck so you ...

@robin no I masked off the fret wire and sanded with the grain. I’ll do a small test with some lemon oil to see if it magically vanishes and if not I’...

@koendb Thanks. It will definitely improve as I’ll clean up the whole board at the end which will leave a much more uniform look too if nothing else. ...

@koendb I was careless filling the fret ends and on two of the frets the glue ran over the front of the board. I’ve managed to clean it up fairly well...

By all accounts Baltic birch ply is the way forward as it’s slow grown and won’t have voids in like you’ll find in standard hardware store ply. Regula...

@igeorgebot Mr @darrenking should be able to help on that one. You could check out the instructions for the one stewmac sell