@hudsoncustoms Here is a link to the utube channel

@tej Some grain fillers do shrink as the solvent dries out, whether it’s water or solvent based there will always be a reduction in volume. The number of coats is something you have to judge as you go...

First of two questions for today, if using a clear grain filler and a dye I’m presuming you’d mix it with the later coats of dye once you have the colour pretty much deep enough for your tastes, sound...

Ok if it’s too quiet I’m up for stirring the pot. I challenge you to cut those horns with a router.

@koendb I’m sure Mark did a live stream on neck through construction.

I challenge you to cut those horns with a router. @rocknroller912 or perhaps a sharp spoon!?

I’m sure Mark did a live stream on neck through construction. @rocknroller912 where can I find his livestreams can see a link from Here too them. Am I missing the obvious Here?

@koendb But your wings should already be roughly shaped. So this is one of the parts I was really unsure with, I’d assumed you wouldn’t cut them to shape as I’d expect you want/need consistant clamp...

@hudsoncustoms sounds like you’re starting with a much clearer view of the end game than I did 😬 Any pictures you’d be happy to share?

Thanks for asking, Tej. I've successfully built my prototype, and have since finalized a multitude of mods, from body shape, pups selection, harness, to final headstock design and neck/board construct...

Thank you, Koendb

@koendb so what’s the plan for getting the build done, I’m not familiar with the approach for neck though, at what point do you join the wings on to the neck? My next build is, in my head, to be neck ...

Hi, This isn't for me (I want to try my hand at finishing my own) but a friend of mine has a Fender Jaguar that is now looking a bit worn and he just asked me if I had any idea what it would cost to r...

@jonhodgson I think Bailey would be a good place to get a quote from. Mark has the best finish on any guitars I’ve seen and probably the longest lasting due to it being oil based.

@rocknroller912 I doubt very much he'd go for an oil finish. He just commented he might want to go for the same colour as his AC Cobra replica, which I can see working. Attachment : steves_cobra...

This isn't for me (I want to try my hand at finishing my own) but a friend of mine has a Fender Jaguar that is now looking a bit worn and he just asked me if I had any idea what it would cost to refin...

He just commented he might want to go for the same colour as his AC Cobra replica, which I can see working. @jonhodgson If you get me the colour code of the car, I can paint the guitar in the exact s...

@steveadams Your videos are never boring, and since I got a new iPad I can even get them on full screen.

Hi Bpower. Is it a tight fit around the heater nozzle and also is the opposite end of the pipe closed off at all. Thanks

@powerful . I just used a pipe and a heat gun. I got a 1 1/2" pipe that would fit over my heat guns tip. Put a bracket on in so I could clamp it in my vice. It is pretty low tech but it worked for the...