@markbailey The photos dont load for me, but I understand what you mean 🙂   I think I am ok now ! my last attempt seems to have resolved the issue.If not, I ‘ll be back 🙂 Cheers guys for…   Read more»

@markbailey thanks mark

Posted by: @markbailey
will share it when the livestreams start back up.

Nice!!Looking forward to it @markbailey

@koendb I’m sorry I can’t offer up any help, other than moral support, it’s not my area of expertise. I feel that this is a mission for @markbailey should he choose to accept it (I know he will). 👍

@markbailey Hi Mark, thanks for your comments. To be honest, I wasn’t sure about the high fret access. It’s prompted a bit of a re-think on my part, and I’ve decided to follow your designs more closely, and if I…   Read more»

@markbailey Hi Mark, thank you for your reply. I should have mentioned it beforehand, but the Aria had a bolt on neck. Is that going to be a problem while following the course?  As far as the pickups are concerned,…   Read more»

@markbailey yes it was. I managed to source some nearby after I trashed it on the first attempt. Slow progress but getting through it. Thanks

Thanks @markbailey, ‘by hand’ looks like the best route. Did you get my contact form message? I don’t seem to be able to access the course content.

I don’t know but if you contact @markbailey by email, I’m sure he can sort it out for you. 👍 
Sorry you are having trouble but it will be put right. 👍

@markbailey thanks Mark, appreciate the help.

Posted by: @eddie6string
Thanks Mark.
Miss you guys!
Warmness 

@eddie6string Nice one flower. 🌼🌸🌺🌼🌸🌺🌼🌸🌺
 
We all miss you @markbailey Hugs and kisses to you both. 😂

@markbailey 
Thanks Mark.
Miss you guys!
Warmness 

 
Eddie

Posted by: @markbailey
Stunning!

@markbailey Thanks, I’ve got to flat and polish it yet so @darrenking’s buffer will be employed again. ✨✨✨✨✨✨

Posted by: @markbailey We use all kinds of finishes here but the UV one is supplied by ‘CUREUV’ @eddie6string Oh yeah, that was it. Sorry, my mistake. Like Mark says, it is very expensive and it’s not good to hear…   Read more»

Posted by: @eddie6string
What is brand name of UV cure finish that Mark uses?

@eddie6string Erm…… Solarez, I think. I could be wrong, you’ll have to check with @markbailey 

@markbailey Thanks Mark, I appreciate it and I appreciate you and what you’ve done for us here. I thought it quite appropriate when I first found you and this site. Why? LOL Well, my family originates from England, Scotland, &…   Read more»

@rathius What a great positive introduction story, I can totally agree with the relaxing bit. I wouldn’t have started this either without a pandemic lockdown or without the help and inspiration from @markbailey and this community. Which part of the…   Read more»

Posted by: @markbailey the main problem is the coarse grain. With hard bits next to soft bits it can be very difficult or near impossible to get all the lumps out Ok, this at least gives me something to go…   Read more»

Posted by: @markbailey
We’ll all be watching and cheering you on whatever…if it explodes you get extra points!

🤣🤣🤣🤣🤣🤣

@markbailey  @boo
Sounds like a good idea, so just for further encouragement, sign me up for the nut making course too.