@robin Great guy that boo, rock that Power Devil Robin!

@eddiesixstring Don't knacker the Lacquer ' is a must for rear Tee shirt print. 😂👍👍👍🤘🤘

@cheesewhisk The picture of the sawdust is great! So what are you planning for your first build?

@boo Here’s how to wire a killswitch, I would go for B as the switch is always grounded and probably helps reduce popping... Attachment : image.png

@robin Definitely Guitar Making Time!!!

@lizard Welcome to the forum Denver! As you’ve already heard and found out, this is a great place full of interest and support. Regarding your neck blank: depending on the dimensions you might be able...

@boo Clean work, nice! I‘m a mad Buckethead fan from waaay back, his use of the kill switch is great! Personally I don’t like the arcade switch, I think it’s too big but to each their own... it works ...

@russ I bet the CA from Titebond is good stuff, reputable company and all. I‘ve never used it but I‘m pretty sure that’s what Mark uses in the vids on the course.

That’s cool, I can take it...

@frocesterbill Great thread and build, Bill. I really liked all the photos. Nice job on the top and f hole. I‘ve never been the biggest fan of semi hollow guitars but I like the thinline style and wha...

@clinton Great work Clinton. I like how you resaw by hand, that’s intense!

@robin Looks like you got there in the end, nice one. Btw if you think those snipped frets are sharp, try some stainless steel... After cutting those you have to immediately file the ends cuz they are...

@rocknroller912 Hmm, I guess heating the garage isn’t such an easy task...

@boo btw, which BKP did you order? Holy Diver? Nailbomb? Painkill-ah?

@robin ahh, I was talking about a handheld jigsaw. I didn’t realize you were talking about a jigsaw... 😆

@rocknroller912 Ah, so you have a shed I guess. Ideally that sounds nice except for the obvious problems of sub zero weather... If you’re not even able to deliver the jobs until the end of March then ...

@prodoozer well alright, nothin’ wrong with that.Best of luck with your builds!

I normally have a sacrificial piece of wood underneath the one I’m cutting/routing. Good tip @boo It would probably be easier (and more fun!) to just make a new template then dicking around with Bon...

@robin the blade goes to a bit of an angle when I push it into the cut. That’s just how jigsaws are I’m afraid. A good trick to reduce blade wandering is to cut your piece on top of some foam board ...

I’ve got a few shortbread/chocolate tins @boo Right on, for sure the one with the Buck and especially that psychedelic Cow!