Few more screws needed, but I’m calling this one done.

Will do. Yeah youtube is where I found his stuff too. I'll stick with Liberon oil, I think Mark recommends that for an oil finish and I used it on ...

Thanks @Koendb. I got one from Dylan pickups:/p>

Sorry to hear Mark and Carol. Best wishes

Thanks @Bill Flude. I’m really happy with how it plays and the neck, weights etc, but should probably get it in the hands of someone else because I’m...

Thanks @mattbeels. The wood came from @mark Bailey.

Fiddly routing is right @tv1. I started by routing the inside hole on a big off cut from the neck blank. Then cut the outside border on the bandsaw an...

Thanks @Russ. I did make those, honestly only because there was a little gap to the fretboard with the supplied ones.

These ones are made in Japan and not sure of brand. I think I’ll proceed and see how they feel with the slightly large holes. I better start checking ...

Hey Matt, thanks. I’m not sure if they are CTS. Will have a look tomorrow. But I measured the diameter and they were just under 8mm. I haven’t routed ...

Thanks @Boo. Ordered the bigger one today.

Thanks Mark. Think I’ll treat myself.

Thanks Mark. Been fun watching the videos. Looking forward to giving it a crack. Cheers